SATO MB200i Specifications download pdf (Page 7)

MB200 Quick Guide Pg 11

Troubleshooting

The status of the printer is shown on the status indicator. To solve the problems, follow the

instructions in the table.

Status

(LED)

Mode Details Cause Remedy

Orange All modes Low battery Battery is not

full

Recharge the

battery

Red/Orange

(blinking)

On-Line Buffer over 1. Received data

over the buffer

quota.

2. The protocol

between the

printer and host

does not match.

1. Adjust the

data amount at

the host side so

that it won’t

exceed the

buffering quota.

2. Match the

protocol.

Red After

turning on

the power

1. Program

error

2. FLASH

ROM error

FLASH ROM

reading/writing

error

1. Replace the

FLASH ROM*

2. Download the

firmware again*

Orange

(blinking)

On-Line Head Error The print head is

damaged

Replace the

head*

Open cover 1. Cover is not

locked

2. Cover micro

switch is not

working properly

1. Lock the

cover

2. Adjust the

micro switch*

Paper end Ran out of paper Set new label

Red

(blinking)

On-Line

Sensor error 1. Sensor level is

not accurate

2. Sensor type

does not match

3. Label is

meandering

1. Adjust the

sensor level*

2. Adjust the

sensor type

3. Reset the label

MB200 Quick Guide Pg 4

Item Details

Interface Connector (RS232C) For the connection to a computer

Interface Cover Covers the interface connector

Front Cover Open this for setting labels

Cover Open/Close lever Opens and closes the front cover

IrDA Adjustment Lever Changes the angle of the IrDA receiving element

IrDA Filter (2 filters) Location of IrDA receiving element

Dispenser Unit Shift this when using the Dispense mode

Power Switch Slide to turn the power on/off

Battery Cover Insertion of battery pack

Belt Hooks Attaches the shoulder belt

Label Guide Adjust this to the label size being used

Label Ejection Collection point for printed labels

Label Width Scale Scale for measuring the width of label used

DC Input Jack Connection of the AC adapter

DC input Jack Cap Covers the DC input jack

Feed Key Press to feed labels

Print Key Press to set the printer to On-line or Off-line

STATUS indicator (LED) Indicates the status of the printer

IrDA filter (2 filters)

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

SATO MB200i Specifications Page 7

Comments to this Manuals

Related products and manuals for Print & Scan SATO MB200i