SATO GL 4xxe Series Installation Guide download pdf (Page 11)

1) Mounting the printer above the rewinder (cont’d)

If the front cover snaps into place correctly,

you can proceed to further tighten the screws

permanently, followed by inserting the

thumbscrew used to secure the printer’s front

cover in the first step of this guide.

Finally, connect the printer power cable as

shown, routing it through the slot at the

bottom of the internal rewinder.

Figure 2h. Plugging the

power cable

Figure 2g. Installing the

thumbscrew

1 2 ... 6 7 8 9 10 11 12 13

No comments

SATO GL 4xxe Series Installation Guide Page 11