SATO MB400 Operator's Manual download pdf (Page 12)

MB400 Quick Guide Pg 9

Installing and Removing Battery Pack

Remove the protection case.

1. Place your finger on the battery cover ribbed

area, and open the battery cover in the

direction of the arrow.

2. Insert the battery pack with the connector

facing towards the end.

* Insert the battery all the way in until the

lock clicks into place.

3. To remove the battery pack, press down the

lock lever and release the lock. Then pull the

battery pack out placing your finger into the

notch.

** Take caution not to drop the battery pack when

removing it. The battery pack may be damaged if it

is dropped.

Battery Status

1. Battery near end

When the battery is getting low, the battery

near end is detected and the BATTERY

LED indicator lights up in orange. The keys

can still be operated, however the battery

should be recharged.

2. Low Battery Error

When the battery is empty, a low battery error is detected and the BATTERY

LED indicator lights up in red. The keys cannot be operated, and after 30 seconds

the power automatically turns off. Make sure to recharge the battery.

Status BATTERY LED indicator

Battery near end Light (orange)

Low battery error Light (red)

** The BATTERY LED indicator does not light up during printing or an error, even if

battery near end or low battery error has been detected.

MB400 Quick Guide Pg 10

Media Loading

Setting Labels

The method of setting labels may vary depending on the print mode.

[Continuous Mode]

1. Press the cover Open/Close lever in the

direction of the arrow to release the front

cover lock.

2. Slide the front cover to open. Hold the

front cover and slide it in the direction of

the arrow until it stops.

3. Open the front cover in the direction of the

arrow.

1 2 ... 7 8 9 10 11 12

Quick Guide 1

Comments to this Manuals

No comments

SATO MB400 Operator's Manual Page 12

Comments to this Manuals

Related products and manuals for Print & Scan SATO MB400