SATO M-84PRO Specifications download pdf (Page 24)

Operation Manual Section 3. Configuration

SATO M-84PRO Page 3-1

SECTION 3.

CONFIGURATION

PRINTER DIP SWITCH CONFIGURATION

DIP SWITCH PANELS

There are two DIP switches (DSW2 and DSW3) located on the front panel under a

protective cover. In addition, a third DIP switch is located on the RS232C Serial

Adapter card and is used to set the RS232C transmit/receive parameters. These

switches can be used to set:

• Thermal transfer or direct thermal mode

• Label sensor enable/disable

• Head check mode

• Hex dump mode

• Single Job or Multi-Job Receive buffer

•Operation mode

Each switch is an eight section toggle switch. The ON position is always up. To set

the switches, first power the unit Off, then position the DIP switches. Finally, after

placing the switches in the desired positions, power the printer back on. The switch

settings are read by the printer electronics during the power up sequence. They will

not become effective until the power is cycled.

RS232 TRANSMIT/RECEIVE SETTING

Data Bit Selection (DSW1-1). This switch sets the printer to receive either 7 or 8

bit data bits for each byte transmitted.

Parity Selection (DSW1-2, DSW1-3. These switches select the type of parity

used for error detection.

DSW1-1 SETTING

Off 8 Data Bits

On 7 Data Bits

DSW1

OFF

12345678

DSW1-1 DSW1-3 SETTING

Off Off No Parity

Off On Even

On Off Odd

On On Not Used

DSW1

OFF

12345678

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

No comments

SATO M-84PRO Specifications Page 24