SATO TG312 Instruction Manual download pdf (Page 125)

Section 7: Interface Specifications

TG3 Series Operator Manual Page 7-15

7.7 LAN AND WIRELESS LAN ETHERNET SPECIFICATIONS

7.7.1 Software Specifications

Protocol TCP/IP

Network layer ARP, RARP, IP, ICMP

Session layer TCP, UDP

Application layer LPD, FTP, TELNET, BOOTP, DHCP, HTTP

Notes

• Send the print data by LPR and FTP of TCP/IP and dedicated socket protocol.

• Use socket connection to get the printer status.

7.7.2 TCP/IP Specifications

In TCP/IP protocol environment, LPD and FTP are provided for printing. TELNET is provided for the setup of

various variables, and ARP, RARP and BOOTP/DHCP for the setup of IP address are available.

In WindowsNT4.0, Windows95/98, WindowsMe, Windows2000, WindowsXP, and WindowsVista

environments, IP address and variables can be set using the [Admin Manager] in the utility of attached CD-

ROM. For more information about [Admin Manager], refer to [Network Utility] in the CD-ROM.

In socket connection, the printing operation and the status are monitored by using [Printer Driver] and [Status

Monitor] in the CD-ROM. In this case, multiple connections cannot be established at the same time. For more

information about [Printer Driver] and [Status Monitor], refer to the instructions in the CD-ROM.

WindowsNT4.0, Windows2000, WindowsXP and WindowsVista operating systems support LPD of TCP/IP

that enables you to print; however, Windows95/98 and WindowsMe are not configured with LPD. In order to

perform printing operation, off-the-shelf printing software is required.

7.7.3 LPD Specifications

LPD protocol complies with RFC1179 and handles the list of logical printer name as queue name such as lp,

sjis and euc. In addition, a banner page can be printed by a proper setup.

When sending a job by LPR, the transmission order of data file/control file within the job does not affect the

printing operation. In addition, if the banner page is specified, it will be added to each data file.

Notes

• A job deletion by LPR is not supported.

• LPD can be used for STATUS4 only

7.7.4 FTP Specifications

FTP protocol complies with RFC959 and handles the list of logical printer name as transfer directory. File

transfer to this directory executes print operation. Note that it is possible to specify ASCII(A), BINARY(I), and

TENEX(L8) as transfer modes, although mode difference is dependent on the client side.

In addition, a banner page can be printed with a proper setup.

There are three directory names such as lp, sjis and euc.

Queue name Kanji filter applied Input Kanji code

lp Not available N/A

sjis Available Shift JIS

euc Available EUC

Queue name Kanji filter applied Input Kanji code

lp Not available N/A

sjis Available Shift JIS

euc Available EUC

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 151 152

Comments to this Manuals

No comments

SATO TG312 Instruction Manual Page 125

Comments to this Manuals

Related products and manuals for Label printers SATO TG312