Section 8: Appendix
TG3 Series Operator Manual Page 8-5
8.4 POSITIONS OF SENSORS AND OPTIONS
Only center hole sensor and Gap sensor are in common use. There is no interference among sensors shown
above.
89.1mm
(3.51”)
I-Mark
7.0mm (0.27”)
126.6mm
(4.98”)
67.4mm
(2.65”)
50.4mm
(1.98”)
176.6mm
(6.95”)
Edge (Notch)
2.5mm
(0.1”)
Center hole/ Gap
12.5 to 43.0mm
(0.49” to 1.69”)
Side hole
19.0 to 80.0mm (0.75” to 3.15”)
Side hole
19.0 to 80.0mm (0.75” to 3.15”)
Center hole/ Gap
12.5 to 43.0mm
(0.49” to 1.69”)
I-Mark
6.0mm (0.23”)
Edge
(Notch)
2.5mm
(0.1”)
Jump hole
13.5mm (0.53”)
Print head
Batch separator
23.0mm (0.9”)
Cutter sensor
23.0mm (1.6”)
Cutter blade
29.2mm (1.15”)
Feed roller
19.1mm (0.75”)
Comments to this Manuals