SATO M-84PRO Specifications download pdf (Page 27)

SATO M-84PRO PN 9001105 Rev. A Page 3-1

SECTION 3.

CONFIGURATION

PRINTER DIP SWITCH CONFIGURATION

DIP SWITCH PANELS

There are two DIP switches (DSW2 and DSW3) located on the front panel under a protective

cover. In addition, a third DIP switch is located on the RS232C Serial Adapter card and is used

to set the RS232C transmit/receive parameters. These switches can be used to set:

• Thermal transfer or direct thermal mode

• Label sensor enable/disable

• Head check mode

• Hex dump mode

• Single Job or Multi-Job Receive buffer

• Operation mode

Each switch is an eight section toggle switch. The ON position is always up. To set the

switches, first power the unit Off, then position the DIP switches. Finally, after placing the

switches in the desired positions, power the printer back on. The switch settings are read by

the printer electronics during the power up sequence. They will not become effective until the

power is cycled.

RS232 TRANSMIT/RECEIVE SETTING

Data Bit Selection (DSW1-1). This switch sets the printer to receive either 7 or 8 bit data bits

for each byte transmitted.

Parity Selection (DSW1-2, DSW1-3. These switches select the type of parity used for error

detection.

DSW1-1 SETTING

Off 8 Data Bits

On 7 Data Bits

DSW1

OFF

12345678

DSW1-1 DSW1-3 SETTING

Off Off No Parity

Off On Even

On Off Odd

On On Not Used

DSW1

OFF

12345678

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 81 82

No comments

SATO M-84PRO Specifications Page 27