SATO MB410i Service Manual download pdf (Page 27)

Unit 3: Setup

MB400i/MB410i Operator Manual PN 9001190C Page 3-7

CHARGING THE BATTERY PACK WITH THE PRINTER

If you purchased the optional AC adapter or your printer comes with the supplied AC adapter, the

printer can be used to charge the supplied battery pack. Follow the steps below:

Figure 3-6, Charging the Battery Pack with the Printer

1. Remove the cover of the printer’s DC input jack and connect the AC adapter’s DC output

terminal to it.

2. Connect the AC adapter to the wall outlet and turn on the power. The POWER lamp on the

adapter lights green. Charging starts and the battery indicator on the printer lights red.

When the battery pack is fully charged, the battery indicator goes off.

In the case of the MB400i/410i Wireless LAN interface model, the Battery Strength segments

(See section, Operation and Configuration) on the LCD screen will appear when charging starts,

and go off when charging is complete.

OTE:

• The AC adapter set used for this printer is specific to this printer. Do not use it for other elec-

tric equipment.

HARGING TIME

With the AC adapter, it takes about 5 hours for the battery pack to reach full charge from a fully

discharged state.

$#OUTPUTTERMINAL

!#ADAPTER

$#INPUTTERMINAL

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 85 86

No comments

SATO MB410i Service Manual Page 27