SATO MB410i Service Manual download pdf (Page 32)

Unit 3: Setup

Page 3-12 PN 9001190C MB400i/MB410i Operator Manual

LOADING THE LABEL ROLL (CONTINUOUS MODE)

The method of installing label media varies with your choice of the two possible print modes—

continuous or dispense mode.

Figure 3-12, Continuous Mode

Figure 3-13, Sliding Dispenser Unit Down

1. Make sure you can see the red platen roller. If not, slide the dispenser unit down, by lifting

its top edge (Tear-off bar) upwards at the two arrow marks. Now push the dark gray Cover

Open/Close lever downwards to release the cover.

Figure 3-14, Adjusting Label Guide Stopper

2. While pressing the label guide stopper, slide the label guide to the width of the label roll

being loaded. (Note the measurement on the inside of printer.)

Continuous mode

Label

Journal paper/

Linerless label

Dispenser unit

Label guide stopper

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 85 86

No comments

SATO MB410i Service Manual Page 32