SATO M-5900RV Specifications download pdf (Page 29)

Operation Manual 3. Configuration

M5900RV 29

3.3.5 Pitch Offset and Direction

The label pitch is the distance from the leading edge (the edge that

comes out of the printer first) of a label and the leading edge of the

next label. The leading edge position of the label can be adjusted

relative to the print head +/- 49 mm in increments of 1 mm using

the following procedure. Once the position is set, it can be adjusted

+/- 3.75 mm using the PITCH potentiometer on the adjustment

panel.

The label pitch is the distance from the leading edge (the edge that

comes out of the printer first) of a label and the leading edge of the

next.

To change the setting perform the following steps:

1. Use the LINE key to step the underlined cursor to either the pos-

itive (+) or the negative (-) selection. A positive selection

increases the label pitch while a negative selection decreases

the label pitch.

2. Once the correct setting is underlined, press the FEED key to

accept the setting and advance to the PITCH OFFSET adjust-

ment.

3. Use the LINE key to step the counter to the desired position.

The display will increment one step for each time the LINE key

is pressed. If the LINE key is held mode. The reading will

advance to a setting of 49 mm after which it will automatically

wrap and start of "00" again. The pitch direction set in the pre-

vious step will be displayed in front of the OFFSET setting.

LINE FEED

DIRECTION

MOVED WITH MINUS(-)

OFFSET

ORIGINAL PRINT LINE

MOVED WITH

POSITIVE(+) OFFSET

3,7&+2))6(7

PP

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 61 62

No comments

SATO M-5900RV Specifications Page 29