SATO MB400 Service Manual download pdf (Page 31)

Unit 3: Setup

MB400i/MB410i Operator Manual Page 3-11

USING THE OPTIONAL AC ADAPTER FOR POWER

If you purchased the optional AC adapter or your printer comes with the supplied AC adapter, the

printer can be operated on AC power instead of the supplied battery pack.

Follow the steps below:

Figure 3-11, Connecting the AC Adapter for Power

1. Remove the cover of the printer’s DC input jack and connect the AC adapter’s DC output

terminal to it.

2. Connect the AC adapter to the wall outlet and turn on the power. The POWER lamp turns

green.

OTES:

• Be sure to turn the printer power off when removing the DC output terminal of AC adapter or

disconnecting the power source. Otherwise, the information stored in the printer may not be

updated.

• A battery pack is unnecessary when an AC adapter is used. If a battery pack and an AC

adapter are being used at the same time, the printer will attempt to charge the battery pack (if

it is not already fully charged).

• The AC adapter set used for this printer is specific to this printer. Do not use it for other elec-

tric equipment.

$#OUTPUTTERMINAL

!#ADAPTER

$#INPUTTERMINAL

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 85 86

No comments

SATO MB400 Service Manual Page 31