Unit 4: Operation and Configuration
MB400i/MB410i Operator Manual Page 4-5
Figure 4-7, Printing a Test Print
3. Press the POWER button while pressing and holding down the FEED button. The printer
enters the test mode. Press the FEED button again to do a test print. Press FEED button to
stop test print.
Verify the following using the output of the test printing.
• All printed characters are solid black, without any chipped areas.
• Overall print quality is readable and sharp.
A low battery condition may affect the print quality. Make sure the printer is running on AC or on a full
battery during a test print.
NOTE:
If any fault is detected, contact your SATO dealer or service center. Before asking for a repair,
please read the Troubleshooting section of this manual.
1234567
ABCDEFG
abcdefg
1234567
ABCDE FG
abcdefg
Comments to this Manuals