SATO MB400 Service Manual download pdf (Page 73)

Unit 5: Operating Modes

MB400i/MB410i Operator Manual Page 5-3

NOTES:

A small label may produce a large amount of data when printing a Hex Dump.

When the onboard buzzer is enabled, it will sound when the printer is turned ON during DIP

switch setting. Release the FEED button to stop the buzzer.

To end any setting for Standard/Non-standard Control Code or Peeling Print or Online Command

compatibility, confirm that the STATUS LED is lit green. Then turn the printer OFF, and reset the

DIP switches as necessary.

WARNING

Never connect or disconnect interface cables (or use switch box) with power applied to either the

host or the printer. This may cause damage to the interface circuitry in the printer/host and is not

covered by warranty.

ON OFF OFF OFF CLOSE OFF OFF Infrared

interface

Normal startup mode

CLOSE OFF ON - Test printing mode

ON OFF ON ON CLOSE OFF OFF Infrared

interface

HEX dump mode

ON OFF OFF ON OPEN ON OFF - Head check (Barcode

printing area) setting

OPEN OFF ON - Head check disabled

ON ON OFF OFF CLOSE OFF OFF USB

interface

Normal operation

CLOSE OFF ON - Test printing mode

ON ON ON ON CLOSE OFF OFF USB

interface

HEX dump mode

OPEN ON OFF - Set compatibility with

MB400 Online Com-

mands

OPEN OFF ON - Set compatibility with

SBPL Online Com-

mands

ON ON OFF ON OPEN ON OFF - Non-standard Control

codes

OPEN OFF ON - Standard Control codes

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 85 86

No comments

SATO MB400 Service Manual Page 73