SATO MB400 Service Manual download pdf (Page 49)

Unit 4: Operation and Configuration

MB400i/MB410i Operator Manual Page 4-11

OPTIONAL LCD SCREEN

The Wireless LAN version of the printer is factory-fitted with a Liquid Crystal Display (LCD). The

screen can display the following information:

Figure 4-11, Wireless LAN Version Liquid Crystal Display (LCD) elements

• Battery strength: Three-segment indicator. When all segments are lit, voltage level is

greater than 15.0 V. Two segments indicate a level of between 14.4 V and 14.9 V. One seg-

ment indicates a level of between 13.6 V and 14.3 V. When all segments are off (voltage level

below 13.5 V), printing is not possible.

• Signal strength: Three-segment indicator to indicate Minimum, Medium and Maximum signal

quality. An X indicates no reception.

• Test Print indicator: Appears in Test Print mode.

• Two-line text display: Displays the following:

1. Various status messages: Firmware version, Online mode, Offline mode, labels remaining

in print queue, Test Print status, Default Setting, Complete, Factory Clear, Press Feed Key,

Press Print Key, Hex Dump Mode, Set up Display, Adjust LCD, Exit, Contrast, Back Light On.

(For more information, see Indicators in the Hardware and Related table in the Basic Specifi-

cations section, Status LED in the Functions of Various Parts table in the Setup section, and

Enabling and Disabling Special Functions in the Operating Modes section.)

2. Warning messages: Cover Open, Paper End, Sensor Error, Buffer Near Full, Head Protect,

Head Error, Module Error. (For more information, see Troubleshooting section.)

3. WLAN information: Messages such as Adhoc mode, Infrastructure mode, IP address, sub-

net mask, default gateway, Socket Port Number.

ADJUSTING DISPLAY CONTRAST

To adjust the contrast of the LCD, go into Maintenance mode. Use the FEED button to select

options, and the PRINT button to confirm a selection.

Now select the “Adjust LCD” option and then the Contrast “option.” Values cycle between 30 and

63.

ONLINE

QTY:0000

MANU

Signal

strength

IP address acquisition method

Bat tery

strength

Tw o- l in e

text

display

Test Print mode

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 85 86

No comments

SATO MB400 Service Manual Page 49