SATO CG4 Series Instruction Manual download pdf (Page 23)

Section 2: Installation

CG4 Series Operator Manual Page 2-9

2.4 LOADING THE CARBON RIBBON (FOR CG408TT, CG412TT ONLY) (cont’d)

From the ribbon supply unit, pass the carbon ribbon

underneath the print head assembly to the ribbon

wind-up unit.

Affix the carbon ribbon to the ribbon core using adhesive

tape, and wind it up several times in the direction shown

by the turn arrow.

Confirm that the ribbon has been loaded as shown in the

figure below or as illustrated on the inner side of the top

cover.

Note:

The dull side (ink side) of the ribbon should be facing outward as it travels through the print head

assembly.

Close the top cover until it clicks into position.

Note:

• Be careful not to get your fingers pinched while

closing the top cover.

After loading the media and the carbon ribbon, do a test

print to check that the media roll and ribbon have been

loaded properly. See Section 3.3 User Test Print Mode

for instructions on how to run test print.

Caution

• When replacing carbon ribbon, bear in mind that the print head and its surrounding area remain hot.

Keep your fingers away from these areas to prevent injury.

• Avoid touching even the edge of the print head with your bare hands.

tape

Ribbon route

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 101 102

No comments

SATO CG4 Series Instruction Manual Page 23