SATO CG4 Series Instruction Manual download pdf (Page 90)

Section 8: Appendix

Page 8-2 CG4 Series Operator Manual

8.1 OPTIONAL ACCESSORIES - CUTTER

The cutter should only be installed by SATO qualified servicing personnel.

8.1.1 To route the media when the cutter is installed

Loading of the media for cutter unit is similar to the usual procedure as explained in Section 2.3 Loading

Labels.

8.1.2 Cut position Adjustment

If the cutting position is not at the regular position as mentioned below, you can change the offset setting

with the SBPL commands.

Notes when using media with optional cutter

• Cutting of Labels

The correct cutting position is at the label gap. Cutting

onto the label must be avoided because the label

adhesive that accumulates on the blade will affect cutter

sharpness.

• Cutting Media with Perforation

As for media with perforation, cutting on or in front of

the perforated lines is prohibited. Cutting in those

locations could cause the media to jam and the printer to

malfunction.

The perforated line +1 mm (+0.04”) is the cut prohibited

zone (see Figure 1).

The folded perforated line +4 to +25 mm (+0.15” to

+0.98”) of fan-folded paper is the cut prohibited zone

(see Figure 2).

Backing paper

Cut Position

Label

Cut Position

Label

Figure 1

Cut prohibited zone

(1mm, 0.04”)

Perforated line

Figure 2

Fold perforation

25 mm, 0.98”

4 mm, 0.15”

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 101 102

No comments

SATO CG4 Series Instruction Manual Page 90