SATO TH208 Instruction Manual download pdf (Page 140)

Section 8: Appendix

Page 8-6 TH2 Series Operator Manual

8.3 OPERATION MODE SELECTION (cont’d)

8.3.3 Dispensing Mode

This mode of operation will peel the liner (paper backing) from the printed label as it is advanced to the

printer’s front. Once the printed label has been removed from the printer for application, the unprinted media

will retract and position itself so the next label may be printed.

This operational mode is specifically applicable to print operations where the label is to be immediately

adhered.

Motion 1 (Backfeed set to After)

When printing starts (A. in the figure below), the media is in the correct position to start printing.

When label 1 is printed, the media is fed forward so the label can be removed (B. in the figure below).

When the label is removed, the media is fed back so that the next label is in the start position (C. and D. in the

figure below).

Dispensing pin

B. Label 1 is

printed.

A. Before

printing

Feed

direction

Print head

C. When label 1

is removed the

media is fed

back.

2 1

D. Label 1 is

stopped just

before the

dispensing pin.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 159 160

No comments

SATO TH208 Instruction Manual Page 140