SATO TH208 Instruction Manual download pdf (Page 18)

Section 2: Installation

Page 2-4 TH2 Series Operator Manual

2.3 LOADING MEDIA (cont’d)

4. After pulling out the media, pass the media through the

media guides and place the leading edge of the media

on top of the platen roller.

Note:

Make sure the printed side of the media is facing

upwards.

5. Close the top cover until it snaps into position.

Notes:

• Be careful not to get your fingers pinched while

closing the top cover.

• To load the media in the dispenser, please refer to

Section 2.3.2 To route the label when using the

dispenser, for further instructions.

6. After loading the media, press power button if printer

is turned off. If printer is on, press C button to clear

Cover open error.

When the printer is ready, press the pause/ feed button

to output the leading part of the media.

Caution

• When replacing media, bear in mind that the print head and its surrounding area remain hot.

Keep your fingers away from these areas to prevent injury.

• Avoid touching even the edge of the print head with your bare hands.

Media guides

Printed side should face

upwards

power button

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 159 160

No comments

SATO TH208 Instruction Manual Page 18