Section 8: Appendix
TH2 Series Operator Manual Page 8-9
8.3 OPERATION MODE SELECTION (cont’d)
8.3.4 Cutter Mode (cont’d)
Motion 2 (Backfeed set to Before)
When printing starts (A. in the figure below), the media is in a position so that the previous label could be cut
off.
Before printing label 1, the media has to be fed back so that label 1 is in the printing start position (B. in the
figure below).
Label 1 is printed and the media is fed forward so label 1 can be cut off. (C. in the figure below).
Comments to this Manuals