Section 8: Appendix
Page 8-8 TH2 Series Operator Manual
8.3 OPERATION MODE SELECTION (cont’d)
8.3.4 Cutter Mode
In Cutter mode, when a label is printed the media is fed forward and cut.
Motion 1 (Backfeed set to After)
When printing starts (A. in the figure below), the media is in the correct position to start printing.
When label 1 is printed, the media is fed forward so the label can be cut off (B. in the figure below).
When the label is removed, the media is fed back so that the next label is in the start position (C. in the figure
below).
Comments to this Manuals