SATO MB400 Service Manual download pdf (Page 41)

Unit 4: Operation and Configuration

MB400i/MB410i Operator Manual Page 4-3

SETTING THE DIP SWITCHES

Figure 4-3, Location of DIP Switch Cover

1. See USB/DIP switch cover in Figure 4-3. Orient the printer with the USB/DIP switch cover

facing you.

Figure 4-4, Printer with DIP Switch Cover Open

2. You can pry open the USB/DIP switch cover so that the DIP switches are accessible to you.

Use a small screwdriver to pry outward the small black vinyl cover labeled DSW on corner of

unit as it is shown in Figure 4-4.

3. Look straight downward into the DIP switch compartment or panel in order to see the white

DIP switches. Next to switch number 1 is a directional arrow showing the On setting direc-

tion. Off is in the opposite direction. Figure 4-4 also shows the On arrow.

4. In order to determine how to set the DIP switches, use the table in the Enabling and Disabling

Special Functions section of the Operating Modes chapter in this manual.

5. To adjust a DIP switch, push the white switch with either the end of a paper clip or a very

small screwdriver.

RS-232C cover

Battery cover

USB/DIP switch cover

RS-232C cover

Battery cover

2341

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 85 86

No comments

SATO MB400 Service Manual Page 41