Unit 3: Setup
Page 3-14 MB400i/MB410i Operator Manual
Figure 3-17, Closing the Cover
5. Close the cover after confirming that the leading edge of the label is outside the printer.
This completes the label installation for continuous mode operation.
LOADING THE LABEL ROLL (DISPENSE MODE)
For operating in the Dispense mode, the following label loading procedures apply.
Figure 3-18, Dispense Mode
Figure 3-19, Adjusting Printer Until You Can See Red Platen Roller
Dispense mode
Label
Linerless Label
with perforation
Comments to this Manuals