Unit 3: Setup
MB400i/MB410i Operator Manual Page 3-15
Figure 3-20, Moving Tear-off Bar Toward You.
On Left is Correct Way. On Right is Wrong Way.
1. Make sure you can see the red platen roller. If not, with the unit’s operations panel facing
you, grip the Tear-off bar, lift it up and move it toward you. This slides the dispenser unit
down toward you. Now, push the dark gray Cover Open/Close lever downward to release
the cover.
Figure 3-21, Adjusting the Label Guide
2. While pressing the label guide stopper, slide the label guide to the width of the label roll
being loaded. Note the measurement.
Comments to this Manuals