SATO MB400 Service Manual download pdf (Page 26)

Unit 3: Setup

Page 3-6 MB400i/MB410i Operator Manual

CHARGING THE BATTERY PACK WITH A CHARGER

If your printer comes with the optional battery charger, you can use it to charge the supplied

battery pack. Follow the steps below:

Figure 3-5, Charging the Battery Pack with a Charger

1. Connect the power cord to the charger unit, then plug it to the wall outlet and turn on the

power.

2. Insert the battery pack into the slot, with the terminal pointing downward. When charging

begins, the CHARGE lamp (red) lights. When charging is completed, the CHARGE lamp

lights green (fully charged).

3. Remove the battery pack when charging is completed.

OTES:

• If the CHARGE lamp does not light at the start of charging, make sure the battery pack is

firmly mounted into the charger. Poor mounting of the battery pack may result in faulty charg-

ing.

• When the fully charged battery pack is placed into the battery charger, the CHARGE lamp

first lights red, then lights green.

• When charging a battery pack that has not been used for a long time, the CHARGE lamp

may blink for a while. This does not indicate an error. You can continue charging.

• The battery pack can be recharged about 300 times (when used at normal temperatures). If

the battery pack is fully charged but runs out quickly, replace it with a new battery. The bat-

tery may still be used, but the battery life may degrade over time.

HARGING TIME

It takes about 1.5 hours for a fully discharged battery pack to return to a fully charged state.

CHARGE

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 85 86

No comments

SATO MB400 Service Manual Page 26