SATO MB400 Service Manual download pdf (Page 48)

Unit 4: Operation and Configuration

Page 4-10 MB400i/MB410i Operator Manual

2. Set up a connection to the Wireless Network

The next step is to ensure that your printer is configured with the proper IP address, subnet

mask, gateway, SSID, Channel, WLAN mode and security settings. Refer to your MIS

personnel for details of your existing wireless network settings. Your SATO-certified System

Integrator/dealer can help to set up the connection to your corporate wireless network. To

configure the printer yourself, consult them for the necessary MB400i/MB410i configuration

software tools and for the Windows print driver.

OTE:

When printing with the WLAN interface, the usable range between the printer and the host may

vary depending on the usage environment and the capabilities of the connected devices.

PRINTING VIA THE OPTIONAL BLUETOOTH INTERFACE

To print using the Bluetooth-enabled version of MB400i/410i, you need to have a Bluetooth-

enabled computing device. Then follow the following two steps.

1. Check the DIP Switches:

The printer’s DIP switches are factory set for Bluetooth operation. Check that DIP switch 1

is OFF and DIP switch 2 is ON. This is the main setting for Bluetooth operation. In case you need

to reset other switches, refer to the full DIP switch settings in the table, Enabling and Disabling

Special Functions in the Operating Modes chapter.

2. Synchronize Bluetooth settings

After setting the DIP-switches, the next step is to ensure that both Bluetooth devices are

configured to operate with the same PIN code and Authentication mode settings. Refer to the

instruction manual of the computing device for details on how to set these parameters. Enter the

default PIN code of 16 zeros.

For the MB400i/410i, these parameters can be set by a SATO-certified System Integrator/

dealer, or by using Bluetooth communication software available from your SATO dealer or

service center. To configure the printer yourself, you may use the MB400i/MB410i configuration

tool and the SATO Windows print driver.

OTE:

When printing with the Bluetooth interface, the usable range between the printer and the host

may vary depending on the usage environment and the capabilities of the connected devices.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 85 86

No comments

SATO MB400 Service Manual Page 48