SATO CL608VA Operator's Manual download pdf (Page 49)

1. Use the LINE key to step the underline to either the positive (+) or negative (-)

selection. A positive selection increases moves the horizontal reference point for

the label to the right edge of the label, towards the outside, while a negative

selection moves the horizontal reference point for the label to the left, towards

the inside of the printer.

2. Once the correct direction setting is underlined, pressing the FEED key will accept

the setting and advance to the Horizontal Offset adjustment.

3. Use the LINE key to step the counter to the desired setting. The display will

increment one step for each time the LINE key is pressed. If the LINE key is held

pressed for more than two seconds, it will automatically go into the fast scroll

mode. The reading will advance to the maximum setting setting (the maximum

Horizontal Offset) after which it will automatically wrap and start at “0000”

again. The Horizontal Direction set in the previous step will be displayed in front

of the Offset setting.

CL608 CL612 CL408 CL412

Horizontal Offset +/-1216 +/-1984 +/- 832 +/-1248

Note: The CL printers will not “wrap” images that extend beyond the print area.

Any part of the image that extends beyond the print area will be truncated.

4. Once the setting is correct, pressing the FEED key will accept the setting and

advance to the Sensor Threshold display.

ABCDEFG

Original Print

Line Position

Moved with both

Vertical and (+)

Horizontal Offset

Label Feed Direction

Inside Label Edge

HOR. OFFSET

H+ 000

Section 2. Installation and Configuration

SATOCL Series Printers9001035 Rev. EPage 2-31

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 255 256

No comments

SATO CL608VA Operator's Manual Page 49