Section 8: Appendix
TG3 Series Operator Manual Page 8-9
8.5 OFFSET POSITION ADJUSTMENT (Cont’d)
8.5.3 Adjustment of Backfeed Distance
The backfeed offset is designed to correct a backfeed distance against forward feed. It is needed when
displacement of media position occurred by some slips or backlashes in paper ejection or feeding motion.
The default values and its motion are described below.
Item Default value
Backfeed offset Tag Center hole +00
Side hole +00
Edge +00
I-Mark +00
Label Gap +00
I-Mark +00
Sensor off +00
Printhead Pitch sensorCut position
Backfeed offset
Normal stop position
Stop position after
forward feed
Stop position after
backfeed
( - )
direction
( + )
direction
Comments to this Manuals