SATO TG312 Instruction Manual download pdf (Page 142)

Section 8: Appendix

Page 8-12

TG3 Series Operator Manual

8.7 JUMP HOLE

Jump hole indicates the tag (such as center hole, side hole, edge (notch) and I-mark) consists of two tags

connected with a red scotch tape at the center of those two. There is a side hole at the center of connected

portion.

For more details, please refer to SATO representatives.

The width of jump-hole tag must be between 37mm (1.5”) and 80mm (3.15”), and the pitch size must be

40mm (1.6”) or more. Also, the center of jump-hole must be at "Vertical position = Pitch (X)/2 in mm or inches,

Horizontal position = 13.5mm (0.53”).

For example: When the tag pitch size is 40mm (1.6”), the vertical position of jump hole is 20mm (0.8”).

The tag with a jump hole is not counted as the number of print, and print operation will go on. Printed tag will

be stacked and a user will remove them manually.

Nothing will be printed on the tag with a jump hole, and the printer will print normally after feeding the next tag

to its start position.

Note that the data may be printed on the tag with a jump hole depending on its size. In this case, the same

data will be printed on the next tag again.

The tag with a jump hole is not counted.

Jump hole

Red scotch tape

13.5 mm (0.53”)

Sensor position

X/2

9 mm

(0.35”)

*Tag pitch size = X (in mm or inch)

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 151 152

No comments

SATO TG312 Instruction Manual Page 142