SATO TG312 Instruction Manual download pdf (Page 147)

Section 8: Appendix

TG3 Series Operator Manual Page 8-17

8.10 RIBBON END

The ribbon sensor on the unwinder side detects a ribbon end error. When the tag and label are fed, but the

ribbon on the unwinder side has not been rotating for 15mm (49.2ft) or more, the ribbon sensor will detect the

ribbon end error.

8.11 RIBBON NEAR END

The ribbon sensor on the unwinder side detects a ribbon near end error. When the ribbon remaining is about

15m (49.2ft) or less, the ribbon near end error occurs.

Note that the ribbon remaining (15m, 49.2ft) is based on the desktop calculation; therefore, the occurrence of

ribbon near end timing may vary depending on the sensor reading conditions.

8.12 MEDIA SIZE CHECK

This function is to check to see if the media type and size set in the printer

match the values specified by the Online Data (ESC A1) command.

Go to the ADVANCED MODE using the operation panel to ENABLE or

DISABLE the CHECK PITCH SIZE function. Refer to

Section 3.9 Advanced

Mode

for more details.

When the CHECK PITCH SIZE is enabled, the media type and size of A1

command contained in the online data will be compared to the values

specified in the printer. If the difference is not within +/-2.5mm (0.1”) or these

specified values are not equal, MEDIA ERROR message will appear.

* The media size specified by A1 command will be shown in "L000-W000".

Notes:

• If the A1 command is not included in the online data, the media size will

not be checked.

• For more details on the A1 command, refer to the Command Specifica-

tions.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152

No comments

SATO TG312 Instruction Manual Page 147