SATO TG312 Instruction Manual download pdf (Page 145)

Section 8: Appendix

TG3 Series Operator Manual Page 8-15

8.8 TAG SORTING METHOD (Cont’d)

8.8.2 Separator (Cont’d)

After tag discharging motion, two tags, which are about 2mm (0.08”) longer and shorter than usual, will be

issued.

Considering the above condition, 2mm (0.08”) at the bottom of the tag will be an unprintable area when using

the separator. Make sure to check the tag length when designing the tag layout.

The tag will not be discharged by pressing the

EJECT button after completing the sorting operation.

If an error occurs (e.g. paper end) during sorting operation, the tags may not be sorted properly.

8.9 PAPER END

8.9.1 End Mark

An end mark will be printed on the tag when paper end error or ribbon near end error occurs. This mark

enables the users to identify valid tag (QTY subtraction) and invalid tag (QTY does not change) at the time of

having such print errors, and the black box will be printed on the invalid tag.

When the cutting motion is activated, an end mark will be printed regardless of position where an error

occurred (within 12mm, 0.47”).

This 12mm (0.47”) is a designed value, therefore, an end mark may or may not be printed depending on the

tag size and the data to be printed.

Usual tag

2mm (0.08”)

Unprintable

First sorted tag

(2mm, 0.08” longer)

First sorted tag

(2mm, 0.08” shorter)

10mm

(0.4”)

12mm or more

Drawing range

Valid tag

Invalid tag

14mm

(0.55”)

Position of

Error occurrence

12mm (0.47”) or

less

Position of

Error occurrence

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 151 152

No comments

SATO TG312 Instruction Manual Page 145