SATO M8485S Operator's Manual download pdf (Page 105)

Line Feed

Command Structure <ESC>Eaaa

aaa = Number of dots (001-999) between the bottom of the

characters on one line to the top of the characters on

the next line

Example: <ESC>E010

Placement: Preceding the text that will use the line feed function

Default: None

Command Function To print multiple lines of the same character size without specifying a

new print position for each line. With the Line Feed command, specify

the number of dots you want between each line. Then, send an ASCII

<CR> at the end of each line of text. The printer automatically

identifies the size of the last character, moves down the number of

dots specified, and begins printing the next line.

Input to Printer

<ESC>A

<ESC>E010<ESC>H0050<ESC>V0050<ESC>L0202<ESC>S

THIS IS THE 1ST LINE<>CR>

THIS IS THE 2ND LINE>CR>

THIS IS THE 3RD LINE>CR>

<ESC>Q1<ESC>Z

Printer Output

Special Notes 1. It is effective only for the current data stream.

2. When printing lines or boxes in the same data stream with the Line

Feed command, the Lines and Boxes command should be

specified last, preceding <ESC>Q Quantity command.

3. This command is invalid only if the value specified is zero.

4. Following this command with a <CR> character will allow you to

print with auto line feed. Tthe print position will be determined

from the value specified and the H value set in the printer. If you

specify several H values after this command, the print position will

be determined by the H value last specified. You must redefine

the font to be used after each H command.

Section 5. Programming Reference

SATO “S” Print Engines 9001034 Rev E Page 5-49

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 227 228

No comments

SATO M8485S Operator's Manual Page 105