SATO M8485S Operator's Manual download pdf (Page 49)

HEX DUMP DIAGNOSTIC LABELS

In addition to the User Test Print Labels (see page 3-16), the printer contents of the

receive and print buffers can be examined using the Hex Dump Test Labels.

Print Buffer Hex Dump

The contents of the Print Buffer can be examined using the Hex Dump mode. The

label numbers each line of data received in the left-hand column, the data in

hexadecimal format in the center columns followed by the same data in ASCII format

in the right-hand column.

1. Turn the printer on.

2. Send and print label.

3. Place the printer in the Off Line mode by pressing the LINE key. The LINE LED

should go out.

4. Place DSW2-4 in the On position.

5. Press the LINE key to place the printer back On Line.

6. Press the FEED key.

7. A label should be printed containing the contents of the print buffer in Hexadecimal

format.

8. Return DSW2-4 to the off position.

9. Turn the printer off and then back on to place it back in the normal print mode.

Receive Buffer Hex Dump

The data that is being received by the printer (before it is placed in the Print Buffer)

can be examined by using the Hex Dump Mode. The label numbers each line of

data received in the left-hand column, the data in hexadecimal format in the center

columns followed by the same data in ASCII format in the right-hand column.

1. Turn the printer off.

2. Place DSW2-4 in the on position.

3. Turn the printer on.

4. Transmit the data to the printer.

5. The data received is printed out on a label in hexadecimal format.

6. Return DSW2-4 to the off position.

7. Turn the printer off and then back on to place it back in the normal print mode.

Section 3. Configuration

SATO “S” Print Engines 9001034 Rev E Page 3-21

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 227 228

No comments

SATO M8485S Operator's Manual Page 49