SATO M8485S Operator's Manual download pdf (Page 160)

2. If the product of the values entered for “dd” and “ee” are not equal

to or less than the value of “fff” (i.e.,“ffff” is greater that “dd” x

“ee”), an error will occur and the symbol will not be printed. It is

recommended that these values each be set to “000” and the

printer be allowed to automatically calculate the optimum values.

3. The values for “dd” and “ee” need to be made larger if the security

level is increased.

4. The maximum data length is 2700 characters, but may be less

depending upon:

- the minimum module dimension (“aa”)

- the security level specified by “c”.

- the number of data characters

5. The Reference Point of the PDF417 symbol is the upper-left corner.

6. The <ESC>F Sequential Numbering command cannot be used with

this command.

7. The <ESC>E Line Feed command cannot be used with this

command.

8. The Macro and Truncated PDF417 symbols are not supported.

9. The values 00

thru 1F

can be specified as print data.

10. This command can be stored in a format.

11. The <ESC>R Rotate command can be used.

12. The print height of the symbol will vary depending upon the data

specified; numeric only, alpha only or alphanumeric.

Section 5. Programming Reference

Page 5-104 9001034 Rev E SATO “S” Print Engines

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 227 228

No comments

SATO M8485S Operator's Manual Page 160