SATO M8485S Operator's Manual download pdf (Page 75)

Base Reference Point

Command Structure <ESC>A3H-aaaaVbbbb

- = This character is optional. When present, it specifies that

the horizontal offset is in the negative direction. If it is left out

the offset direction is positive.

aaaa = Horizontal Print Offset (see Note 7 for field range)

bbbb = Vertical Print Offset (see Note 7 for field range)

Example: <ESC>A3H100V0050

Placement: Preceding all images that are based on the new base

reference point

Default: Current V and H offset setting in the printer configuration

Command Function To establish a new base reference point for the current label. The

base reference point is the top left corner or “origin” from where all

print position commands are based.

This command may be very helpful when using labels less than four

inches wide to place images on the printable label surface. It may

also be used to move images past preprinted fields on a label.

Input to Printer:

<ESC>A<ESC>L0202

<ESC>H0025<ESC>V0025<ESC>WB0MNORMAL REFERENCE POINT

<ESC>A3H0300V0075

<ESC>H0100<ESC>V0050<ESC>WB0MNEW REFERENCE POINT

<ESC>Q1<ESC>Z

Printer Output:

Section 5. Programming Reference

SATO “S” Print Engines 9001034 Rev E Page 5-19

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 227 228

No comments

SATO M8485S Operator's Manual Page 75