SATO M8485S Operator's Manual download pdf (Page 156)

Label Set #2

Special Notes 1. The maximum number of <ESC>FX Sequential Numbering

commands that can be used in one job is eight.

2. In the example above four total labels will be printed

(<ESC>FX002+005003<ESC>DC00006000), the sequential

numbering will start at position 5 and the three digits “600” will be

incremented in steps of 1. A total of two sets of labels will be

printed, the first set of two labels with the value “00006000” and

the next two label set with the value “00006010”.

Label Set #1 Label Set #2

1st Label 00006000 3rd Label 00006010

2nd Label 00006000 4th Label 00006010

3. The <ESC>Q Label Quantity command must be set for the total

number of labels to be printed. In the above example, the value

for the <ESC>Q command should be 2 sets x 2 labels/set = 4. If,

in the above example, it was set to a value of “1”, only the first

label would be printed.

Section 5. Programming Reference

Page 5-100 9001034 Rev E SATO “S” Print Engines

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 227 228

No comments

SATO M8485S Operator's Manual Page 156