SATO M8485S Operator's Manual download pdf (Page 25)

ADJUSTING THE LABEL SENSOR

The “S” printers can position labels using either a label gap (transmissive) or an

Eye-Mark (reflective) sensor. The sensor used is selected by DSW2-2 (page 3-2). The

gap sensor position can be adjusted over a limited range. In addition, the signals from

the sensors can be adjusted using the LCD panel (page 3-13) to compensate for

different liner opacities and/or Eye-Mark reflectance values.

M-8459S M-8460S M-8485S M-8490S

Max Label Width

(includes liner)

5.27" (134 mm) 6.5 “ (165 mm) 5.27" (134 mm) 5.27" (134 mm)

Max Print Width 4.4" (112 mm) 6.0" (152 mm) 5.0" (128 mm) 4.4" (112 mm)

Gap Sensor

Adjustment Range

0.5" to 2.67"

14 mm to 68 mm

0.5" to 3.25"

14 mm to 82 mm

0.5" to 2.67"

14 mm to 68 mm

0.5" to 2.67"

14 mm to 68 mm)

Non-Print Area 0.12" (3 mm) 0.12" or 0.25"

3 mm or 6.5 mm

0.12" (3 mm) 0.12" (3 mm)

Print Head

Inside Frame

Inside Label Edge

Eye-Mark on Back Side of Liner

Minimum Width = 0.25" (6 mm)

Maximum Width

Maximum Print Width

Gap Sensor Adjustment

Non-Printable Area

Minimum Length = 0.5" (12 mm)

Section 2. Installation

SATO “S” Print Engines 9001034 Rev. E Page 2-9

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 227 228

No comments

SATO M8485S Operator's Manual Page 25