SATO M8485S Operator's Manual download pdf (Page 76)

Special Notes 1. Use of this command will set the Vertical/Horizontal Offset setting of

the printer configuration until a new Base Reference Point

command is issued or the setting is changed from the operator

panel. See Section 2: Printer Configuration.

2. This command may be used more than once in a print job.

3. An alternative to using this command is to make changes to your

current Horizontal and Vertical Print Position commands (see

Page 5-20).

Example:

Let’s say the current base reference point is H=1, V=1 and you

wish to move all the fields on your label downward vertically by

150 dots. You could either (1) add the Base Reference Point

command or (2) change all the vertical position commands by an

additional 150 dots.

4. For a more detailed example of the Base Reference Point

command, see “Print Area” in this section (Page 5-4).

5. The “S” print engines can print as close as 2mm to the inside edge

of the label.

6. The “S” print engines will not “wrap” (i.e. if any part of a character

or image extends beyond the last print dot position, it will

disappear and not be visible on any part of the label).

7. The allowable field ranges for this command are:

M-8459S M-8460S M-8485S M-8490S

Horizontal

aaaa

-896 to 896 -1216 to 1216 -1024 to 1024 -1344 to 1344

Vertical

bbbb

0001 to 1424 0001 to 1424 0001 to 1424 0001 to 2136

Section 5. Programming Reference

Page 5-20 9001034 Rev E SATO “S” Print Engines

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 227 228

No comments

SATO M8485S Operator's Manual Page 76