SATO M8485S Operator's Manual download pdf (Page 22)

MEDIA LOADING

Ribbon Loading (not applicable for the M-8459S)

1. Open the print head by rotating the Head

Latch until the head releases. It is

spring-loaded in the open position.

2. Place a new ribbon roll on the Ribbon

Unwind Spindle and push it onto the

spindle as far as it will go. Make sure the

ribbon wil unwind from the top of the

roll. Note that all SATO ribbons are

wound face-in (the ink or dull side faces

toward the inside of the roll).

3. Place an empty ribbon core on the Ribbon

Wind Spindle and push it onto the

spindle as far as it will go.

4. Unwind the clear ribbon leader until about

12 inches of leader/ribbon are off the roll.

5. Route the ribbon as shown in the Ribbon

Routing Diagram on the inside of the

cover.

6. Tape the end of the ribbon leader to the

empty core so that it will underneath the

core and over the top (see diagram on

inside of cover).

7. Manually wind approximately three turns

of ribbon on the core.

8. Inspect the ribbon to make sure it is not

folded over or excessively wrinkled as it

passes over the print head.

9. If labels are already loaded, close and latch

the print head.

New Ribbon

Empty Core

Section 2. Installation

Page 2-6 9001034 Rev. E SATO “S” Print Engines

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 227 228

Comments to this Manuals

No comments