SATO M8485S Operator's Manual download pdf (Page 37)

start at 4 again. The Pitch Direction set in the previous step will be displayed in

front of the Offset setting.

4. Once the setting is correct, pressing the FEED key will accept the setting and

advance to the next Offset digit. Again use the LINE key to step to the desired

setting (0 thru 9). Once the setting is correct, pressing the FEED key will accept

the setting and advance to the Cancel Print Job display.

5. You may wish to check your settings by printing a test label after you have

completed the adjustments to ensure that they are correct. See page 3-16 for

instructions on how to print a test label.

Cancel Print Job

If the printer has a print job(s) loaded in memory, selecting YES will cause the job(s)

to be cleared. The default selection is NO. Make sure that you want to cancel the

print job before selecting YES as the job cannot be recovered and will have to be

retransmitted to the printer.

1. Use the LINE key to step the underline cursor to either the YES or NO selection.

2. Once the correct setting is underlined, pressing the FEED key will accept the

setting and terminate the User Mode of operation and return you to the Normal

Mode OFF LINE display.

If you wish to change any of the settings, you must enter the User Mode again by

simultaneously pressing FEED and LINE keys for more than one second.

Advanced Mode Setup

ABCDEFG

Original First

Line Print

Position

Must be moved

with Minus (-)

Offset to print

on leading

edge of label

Moved with

Positive (+) Offset

to print on trailing

edge of label

Label Feed Direction

Leading Edge of Label as

detected by the sensor

Sensor Position

CANCEL PRINT

NO YES

Section 3. Configuration

SATO “S” Print Engines 9001034 Rev E Page 3-9

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 227 228

No comments

SATO M8485S Operator's Manual Page 37