SATO M8485S Operator's Manual download pdf (Page 46)

2. Once the desired label size setting is underlined, pressing the FEED key will cause

a label to be printed if LARGE was underlined. If SMALL was underlined, the

display will advance to the Print Size display.

Print Size

If SMALL was selected, the Print Size message will be displayed. You must enter the

width of the label. The minimum and maximum label width that can be selected is:

Label Width M-8459S M-8460S M-8485S M-8490S

Minimum 4 cm

1.6 in.

Maximum 11 cm

4.3 in.

15 cm

5.9 in.

12 cm

4.7 in.

11 cm

4.3 in.

Pressing the LINE key will increment the setting by 1 cm for each time the key is

pressed. Once the maximum size is reached, the display will wrap around and start

incrementing at 04 cm again. Once the correct label width is selected, pressing the

FEED key will initiate the print. The SMALL label only contains a head check pattern.

If you wish to pause the printer after it starts to print a test label, press the LINE key

to place it Off-Line. Pressing the LINE key again will place the printer back On Line

and the test label will resume printing. If you wish to stop the test label print, pause

the printer and then turn power off without placing it On Line.

USER TEST PRINT

LARGE SMALL

PRINT SIZE

4cm

Section 3. Configuration

Page 3-18 9001034 Rev E SATO “S” Print Engines

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 227 228

No comments

SATO M8485S Operator's Manual Page 46