SATO M8485S Operator's Manual download pdf (Page 44)

Ignore CR/LF

Under certain circumstances, it is desirable to filter out all CR/LF combinations from

the data stream. Selecting YES for this setting will strip all CR/LF commands from the

data stream, including graphics and 2D bar codes.

1. Step the underline cursor to the desired setting with the LINE key

2. Once the desired setting is selected, pressing the FEED key will accept the setting

and advance to the next display.

Exit Mode

This allows you to exit the Advanced Mode or to recycle through the selections again.

1. Use the LINE key to step the underline cursor to either the YES or NO selection.

The default position is NO.

2. Once the correct setting is underlined, pressing the FEED key will advance the

display to the OFF LINE mode if YES was underlined or back to the Advanced

Setup Mode display if NO was selected.

Advanced Mode Counters

An Advanced Counter Mode is provided for reading and clearing the internal

counters. They allow the user to keep track of the number of centimeters of label

material that has passed through the printer, how many labels have been dispensed

or how many labels have been cut.

To enter the Advanced Mode, the printer is powered on while pressing the LINE key.

The printer will beep one time and display Advanced Mode on the LCD panel.

Pressing the LINE key will advance the display to the Advanced Counter Mode

display.

YES NO

IGNORE CR/LF

EXIT MODE

YES

SETUP

ADVANCED MODE

COUNTERS

ADVANCED MODE

Section 3. Configuration

Page 3-16 9001034 Rev E SATO “S” Print Engines

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 227 228

No comments

SATO M8485S Operator's Manual Page 44